Parts And Operating Controls; Before Using For The First Time; Boiling Water - Bosch TWK 78 series Instruction Manual

4
Congratulations on purchasing this
Bosch appliance. You have acquired
a high-quality product that will bring
you a lot of enjoyment.
Parts and operating
controls
1 Kettle (with water level indicator)
2 Lid with lock
3 Lid release button
4 ON/OFF O switch, illuminated
5 Limescale filter (removable)
6 Base
7 Cable tidy
Important: Use the kettle 1 only with its
included base 6.
● Only fill the kettle with water. Milk and
instant beverages will burn and damage
the appliance. Never operate the kettle
1 without water and do not overfill it;
observe the 0.5 and max markings. If the
kettle is too full, the water will boil over!
Before using
for the first time
● Remove any stickers or film.
● Unroll the right amount of cable from the
cable tidy 7 and plug it in.
● Fill the kettle 1 with water. Bring the water
to a boil and discard it. Repeat the proce-
dure. This will make sure that the kettle is
clean for normal use.
● When the water comes to a boil for the
first time, add a tablespoon of white
vinegar.
Robert Bosch Hausgeräte GmbH

Boiling water

● Fill the kettle with fresh water through the
spout or the open lid 2 (press lid release
button 3).
● Read the quantity on the water level indi-
cator. Do not fill with less than 0.5 litres or
more than 1.7 litres of water!
● Close the lid 2 until it locks and place the
kettle 1 on the base 6.
● Press down the switch 4; the switch lights
up. The water is heated.
● The kettle switches off automatically once
the water has boiled.
The appliance can also be switched off
at any time by pulling up the ON/OFF O
switch 4.
Warning: If you remove the kettle 1 from
the base and replace it before the heating
process is over, the kettle will continue to
heat the water.
N.B.: Only operate the kettle with the lid 2
closed and the limescale filter 5 inserted,
otherwise the kettle will not switch off.
For physical reasons, the base 6 may
collect some condensation water. This is
normal; it does not mean that the kettle 1
leaks.
After boiling, let the kettle cool down for
5 minutes before refilling it with water.
Do not turn on the appliance if the kettle 1
is empty, otherwise the overheat control will
engage and the appliance will switch itself
off automatically.
en