Only For Training And Service Purposes - LG GB230 Service Manual

3. TECHNICAL BRIEF
3.12.2 Digital Part
The digital part of the X-GOLD™213 audio front-end comprises an interface to the TEAKLite® bus, interfaces
to the interrupt units of TEAKLite®, digital interpolation filters for oversampling digital-to-analog conversion,
digital decimation filters for analog-to-digital conversion and an interface to the analog part of the audio
front-end. For the digital microphone all the filtering is done in a dedicated hardware. The output sample
stream is then fed in a duplicated ring buffer structure like the data from the analog microphone path (after
A/D conversion and subsequent digital filtering).
▪ Interpolation Filter
The interpolation path of the X-GOLD™213 audio front-end increases the sampling rate of the audio samples
to the rate of the digital-to-analog converter. Because the input sampling rates can vary between 8 kHz and
47.619 kHz the filter characteristic and oversampling ratio can be adjusted to the respective sampling rate.
The requirements for the interpolation filters depend on the sampling rate, because a sufficient out-of-band
discrimination in the audio frequency band (20 Hz,...,20 kHz) has to be ensured.
▪ Decimation Filter
The digital decimation filter on X-GOLD™213 has two operating modes: 8 kHz output sampling rate and 16
kHz output sampling rate (or 16 kHz output sample rate and 16kHz bandwidth in case of doubled ASMD
clock).
3.12.3 Analog Part
The analog part of the X-GOLD™213 audio front-end in audio-out direction consists of a stereo digital to
analog converter (multi-bit oversampling converter) which transforms the output of the digital interpolation
filter into analog signals. It is followed by the gain control/amplifier section. The DAC outputs can be
switched to several output buffers. In audio-in section there is an input multiplexer which selects either one
of two differential microphone inputs to be connected to the low-noise amplifier and analog pre-filter. The
signals from the analog pre-filter are input to a second-order sigma-delta analog-to-digital converter. In
addition there is a connection for FM-radio playing.
▪ Audio-out Part
The analog audio-out part consists of two multi-bit digital-to-analogue converters (DAC) and an output
stage. The signal sources are switched to the output drivers in the output stage. The output drivers consist
of: a) one mono, differential class-D Loudspeaker driver, b) one mono, differential Earpiece driver and c) one
stereo, single-ended (with uni- or bipolar signals), Headset driver.
LGE Internal Use Only
LGE Internal Use Only
Copyright © 2007 LG Electronics. Inc. All right reserved.

Only for training and service purposes

- 56 - Copyright © 2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes