Block Diagram; Special Function With Press Key; Circuit Function Description; Main Board - Envision EN9110 Service Manual

Hide thumbs Also See for EN9110:
Table of Contents

Advertisement

555
6655-1 SPECIAL FUNCTION WITH PRESS-KEY
Press menu button during 2 seconds along with plug-in the DC Power cord:
That operation will set the monitor into "Factory- mode", in Factory mode we can
do the White balance adjustment with RS232 .In Factory mode, OSD-screen will
locate in left top of screen. Press POWER-button off to on once will quit from
factory mode and back touser-mode. The OSD-index explanation is as following:
1. No signal: No signal input (Signal-cable not connected).
2. Input not supported:
a. Input frequency out of range: H > 92kHz, v > 85Hz or H < 31kHz, v < 55Hz
b. Input frequency out of VESA-spec. (Out of tolerance too far)
5-2

CIRCUIT FUNCTION DESCRIPTION

5-2-1 main board

1. U600, scaler IC gm5020 (all-in-one chip solution for ADC, OSD, scalar and
interpolation):
USE for computer graphics images to convert analog RGB data to digital data with
interpolation process, zooming, generated the OSD font, perform overlay function
and generate drive timing for LCD-PANEL.
2. U502, W78E65 (WINBOND- MCU, type 8052 series with 64k Rom-size and 512
byte ram):
Use for calculate frequency, pixel-dot, detect change mode, rs232-communication,
power-consumption control, OSD-index warning, ...etc.
3. U301,ATMEL12524C02N
EEPROM type, 1K ROM-SIZE, for saving Digital DDC-CONTENT.
4.
U302, MIRCOCHIP24LC21A
EEPROM type, 1K ROM-SIZE, for saving Analog DDC-CONTENT.
4. U501, 24C16 (ATMEL IC):
EEPROM type, 16K ROM-SIZE, for saving AUTO-config data, White-balance data,
and Power-key status and Backlight-counter data.
5. U901,SI8050(switching regulator 12V to 5V with 3A load current) .
6. U904,AIC 1084-33CM (AIC brand linear regulator 5V to 3.3V)
7. U902,RT9164(Linear regulator 5V to 2.5V)
8. U201,U202,LVDS ( use NOVATEK NT7181F)
Convert the TTL signal to LVDS signal , the advantage of LVDS signal is : the
wire can be lengthen and eliminate wire number , low EMI .LVDS signal is high
frequency but low voltage, only 0.35 VPP ,the frequency is seven times higher than
TTL
55

BLOCK DIAGRAM

14

Advertisement

Table of Contents
loading

Table of Contents