Emergency Switch; Led Screen - Toyotomi TAD-T32G Service Manual

OPERATION
Blue/ Red/Green
Blue/ Red/Green
Emergency ON/OFF Switch
This switch is used when unit needs temporary on/off.
●
When press emergency button, unit starts running. The
●
running mode and fan speed mode are set at auto.
Press emergency button again, unit stops running.
●

LED Screen

Please refer to below chart for detail.
Note: Orange LED presents Red/Green lights up
simultaneously.
Running mode
●
Cooling mode(Blue) Dehumidify mode(Orange)
Note: Under AUTO mode, unit will change its
running mode.
Running and TIMER "off"
●
Cooling mode(Blue) Dehumidify mode(Orange)
Note: Under AUTO mode, unit will change its
running mode.
Stand-by and TIMER "on"
●
All mode
Water tank full
●
Note: Water tank full, red LED indicator flashes. When
water full, unit stops running, After discharge
water from tank, please press power on/off
button to operate the units and unit will be in
the mode before water tank full.
indicator
indicator
Fan mode(Green)
Fan mode(Green)
Blue indicator

Emergency switch

Fiter Cleaning Indicator
●
Cooling mode(Blue) Dehumidify mode(Orange)
Note:
1. Display only when in running mode.
2. When unit is running, clean indicator lights, please
clean filter, After cleaned, press reset button on
remote control or press on/off button on unit for 4
seconds to delete the clean indicator lights. The
setting is completed after one beep.
Default indicator
●
• Trouble shooting when environmental temperature indicator failures:
Please check the environmental temperature indicator on PCB
if it's assembled properly and no wires loosen.
• Trouble shooting when coil tube temperature indicator failures:
Please check the environmental temperature indicator on PCB
if it's assembled properly and no wires loosen.
• EEPROM failure:
After units turns on, it will check EEPROM every 4 minutes. If
continuous failure for 5 times, it will be indicated "failure". When
perform EEPROM checking next time and get normal feedback,
the operation will go back to normal. If not, need to replace PCB.
• Water full switch alarm indicator:
Drain the water into a prepared container by the drainage pipe on the
rear panel of the unit. If still doesn't work, please consult a qualified
technician.
5
Easy operation
●
Blue/ Red/Green indicator
Blue/ Red/Green indicator
Fan mode(Green)