Connecting The Propane Tank - HAMPTON BAY 68164 Use And Care Manual

Assembly (continued)
8
Assembling the reflector
WARNING: Remove the protective cover before assembly.
NOTE: Leave all screws and nuts loose until the entire
reflector is put together in order to ensure proper alignment
of all sections.
□ Slide two pieces of the reflector (A) together. Insert one
small screw (LL). Repeat until all pieces of the reflector are
connected.
□ Place cap nuts (KK) on the screws (LL).
□ Place the reflector center plate into the middle of the
reflector panels and repeat this procedure.
9
Attaching the reflector assembly
□ Slide three large flat washers (HH) over the threaded end of
the studs (FF).
□ Place the reflector assembly (A) over the studs (FF) and flat
washers (HH).
□ Place three more flat washers (HH) over the studs (FF) and
secure the reflector in place using three wing nuts (GG).

Connecting the Propane Tank

REQUIREMENTS
□ This heater requires propane gas and a propane cylinder (not included). Use a standard 20 lb. propane cylinder only.
□ Use this heater only with a propane vapor withdrawal supply system. For more information on this requirement, see Chapter 5 of the
Standard for Storage and Handling of Liquefied Petroleum Gas, ANSI/NFPA 58. Your local library or fire department should have this
book.
□ The minimum permissible gas supply pressure of 10 W.C. is required for the purpose of input adjustment.
□ The minimum hourly rate of 17,000 BTUs is the required input rating for a heater for automatic operation at ratings less than full
input rating.
□ The pressure regulator and hose assembly supplied with the appliance must be used.
□ The installation must conform with local codes, or in the absence of local codes, with National Fuel Gas Code, ANSI Z223.1.
□ A dented, rusted, or damaged propane cylinder may be hazardous and should be checked by your cylinder supplier. Never use a
propane cylinder with a damaged valve connection.
□ The propane cylinder must be constructed and marked in accordance with the specifications for LP gas cylinders of the U.S.
Department of Transportation (DOT).
□ Never connect an unregulated propane cylinder to the heater.
A
FF
HH
9
Please contact 1-855-HD-HAMPTON for further assistance.
LL
GG
HH
A
HAMPTONBAY.COM
KK