Table of Contents
Advertisement
ADA70 Specifications
Satellites
Drivers (per satelite)
Satellite Power
Frequency Response
Input Impedance
Input Sensitivity
Signal-to-Noise Ratio
Subwoofer
Driver
Subwoofer Power
Frequency Response
Signal-to-Noise Ratio
Built in Power Supply
UL/CUL/CE Approved
System Requirements
Pentium Processor 100 MHz or higher
16 MB RAM
Windows 98
USB host hub connector
One Year Limited Warranty
Altec Lansing Technologies, Inc. warrants to the end user
that all of its computer speaker systems are free from defects
in material and workmanship in the course of normaland
reasonable use for a term of one year from the date of
purchase.
This warranty is the exclusive and only warranty in effect
relative to Altec Lansing computer speaker systems and any
other warranties, either expressed or implied, are invalid.
Neither Altec Lansing Technologies, Inc. nor any authorized
Altec Lansing Technologies, Inc. reseller is responsible for
any incidental damages incurred in the use of the speakers.
(This limitation of incidental or consequential damage is not
applicable where prohibited.)
Altec Lansing Technologies, Inc. obligation under this
warranty does not apply to any defect, malfunction or failure
as a result of misuse, abuse, improper installation, use with
faulty or improper equipment or the use of the computer
speaker systems with any equipment for which they were
not intended.
The terms of this warranty apply only to computer speaker
systems when such speakers are returned to the respective
authorized Altec Lansing Technologies, Inc. reseller where
they were purchased.
Under the terms of this warranty the original consumer
purchaser has certain legal rights and may have other rights
which vary worldwide.
One 3 inch full range
One 1 inch dome tweeter
14 Watts (7 watts per driver) at
>0.8% THD
250 Hz - 20kHz
>10k ohms
500mV for output
>65dB
One 6 1/2 inch dual voice coil
20 Watts @ <0.8%THD
35 Hz-250 Hz
>65dB
RF Breakthrough Advisory
If this product is placed too close to a high level source of RF
energy, RF breakthrough may be experienced which can cause
some audio disturbance. If this happens, move the product as
far away as possible from the source until the disturbance is
eliminated. Using an audio input cable with a high percentage
of shielding is also helpful in reducing or eliminating interference.
The FCC Wants You to Know
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15
of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
a) Reorient or relocate the receiving antenna.
b) Increase the separation between the equipment and
receiver.
c) Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
d) Consult the dealer or an experienced radio/TV technician
for help.
FCC Warning
Modifications not expressly approved by the manufacturer
could void the user authority to operate the equipment under
FCC Rules.
3
Advertisement
Table of Contents
