Belt Clip & Optional Headset - AT&T E1812B User Manual

Getting started
Belt clip & optional headset
Install belt clip as shown below if desired.
Snap belt clip
into notches
on both sides
of handset.
For hands-free telephone conversations, use any industry standard 2.5 mm
headset (purchased separately).
headset. To order an AT&T 2.5 mm headset, visit our website at
www.telephones.att.com or call 1 (800) 222-3111. In Canada
dial 1 (866) 288-4268.
For best results, use an AT&T 2.5 mm
Plug 2.5 mm headset into
the jack on the side of hand-
set (beneath small rubber
cap).
To release belt clip
from handset, lift one
side of the belt clip
out of the notch.
NOTE: If the sound quality of
the headset is not good, try unplug-
ging it, and firmly plugging it in again.
10