Sharp UX-P115 Service Manual page 15

3.12. Entry data receive
In this mode, the registered data sent from the other machine is receiv-
ed and the received data is registered in the machine. When this mode
is used for receiving, the other machine must be in the entry data send
mode.
After receiving is completed, the following lists are printed.
1.Telephone list data
2.Sender register data (*)
3.Optional setting list (*)
4.Soft switch content
5.Junk fax number list (*)
6.Recording setting list data (*)
(*): Refer to SETUP LIST
4. How to make soft switch setting
To enter the soft switch mode, press the following key entries in sequence.
Press FUNCTION
DATA No.
S F T SW-A1 = 0 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A1 = 1 0 0 0 0 0 0 0
S F T SW-A2 = 0 0 0 0 0 0 0 0
S F T SW-O6 = 0 0 0 0 0 0 0 0
9 8 7
1 2 3 4 5 6 7 8
The soft switch mode is terminated.
2 – 4
START START
Press FUNCTION key.
Press key.
Press key.
Bit1 - 8 are set.
Press START key during setting.
Soft SW-A2 - SW-O6 are set.
To finish the settings halfway between
SW-A1 and SW-O6, press the STOP
key. In this case, the setting being done
to the SW No. on display will be nullified
while settings done to the preceding
SW No. remain in effect.
When the COPY key is pressed, the
contents of soft switches are printed.
UX-P115U