Sharp MD-C2 Service Manual page 15

How to remove the sled motor/loading motor
(See Fig. 15-1)
1. Remove the screws (D1) x 4 pcs., and remove the sled
motor/loading motor.
Caution:
Be careful so that the gear is not damaged.
(The damaged gear emits noise during searching.)
How to remove the spindle motor
(See Fig. 15-2)
1. Remove the screws (E1) x 3 pcs., and remove the spindle
motor.
Caution:
Be careful so that the turntable is not damaged.
To reinstall the spindle motor, the position of the spring
should be as shown in the drawing.
How to remove the optical pickup
(See Fig. 15-3)
1. Remove the screws (F1) x 3 pcs.
Caution:
Be careful so that the gear is not damaged.
(The damaged gear emits noise during searching.)
(D1) x2
ø1.7 x2mm
Loading Motor
Turn Table
A
Spring
Metal
Spindle Motor
Metal
Spring
View from A
(F1) x1
ø1.7 x9.5mm
Optical Pickup
– 15 –
MD-C2
(D1) x2
ø1.7 x2mm
Sled Motor
Figure 15-1
Spring
Turn Table
Spindle Motor
(E1) x2
Screw,Special
(E1) x1
ø1.7 x2.1mm
Figure 15-2
(F1) x1
ø1.7 x3mm
(F1) x1
ø1.7 x9.5mm
Figure 15-3