DIMMs
To remove the component:
Power down the server (on page 29).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 30).
o
Remove the server from the rack (on page 31).
o
Remove the access panel
4.
Open the DIMM slot latches.
5.
Remove the DIMM.
6.
To replace the component, reverse the removal procedure.
Heatsink blank
CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Power down the server (on page 29).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 30).
o
("Access
panel" on page 35).
To prevent improper cooling and thermal damage, do not operate the server unless
Removal and replacement procedures 43