Charging - Doro PhoneEasy 623 Manual

IMPORTANT!
Use only compatible memory cards for use with this device. Compatible
card type: microSD, microSDHC.
Incompatible cards may damage the card itself, the device and corrupt
data stored on the card. Depending on the market some phones may
have a pre-installed memory card.
CAUTION
Only use batteries, charger and accessories that have been approved
for use with this particular model. Connecting other accessories may
be dangerous and may invalidate the phones type approval and
guarantee.
When the battery is running low,
heard. To charge the battery, connect the mains adapter to a wall socket
and to the charging socket y.
When the charger is connected to the phone,
and when it is disconnected. The battery charge indicator will be ani-
mated while charging. It takes approximately 3 hours to fully charge the
battery.
When charging is completed,
is turned off when the charger is connected to the phone only the battery
charge indicator will be shown on the display.
Note! To save power the LCD backlight goes off after a while. Press any
button to illuminate the display. Full battery capacity will not be reached
until the battery has been charged 3–4 times. Batteries degrade over
time, which means that call time and standby time will normally
decrease with regular use.
Save energy
When you have fully charged the battery and disconnected the charger
from the device, unplug the charger from the wall outlet.
English

Charging

is displayed and a warning signal is
is displayed on the screen. If the phone
2
is displayed briefly,