Connecting A Usb Storage Device; Connecting The Aerial - Sandstrom S40LDIB10 Instruction Manual

Connecting a USB Storage Device

1. Switch off the TV before connecting any USB storage device.
2.
Connect your USB storage device to the USB port of your TV.
3.
Plug the connected devices into the mains socket before switching on the
TV.
4. Press the button to turn on your TV.
5. Source button to display the input source list. Press the
Press the
the button to confirm. (refer to page 35 for details.)
• If a hard disk is used, make sure its mains adapter is connected to the mains supply.
• The maximum supported storage space of the hard disk is 1 TB.
• The file system only supports FAT32 format.
• Disconnect the USB storage device if it is not in use.
• The TV may take a few seconds to read the content in your USB storage device.

Connecting the Aerial

Connect one end of the RF coaxial cable to the aerial socket on the
wall and the other end of the cable to the ANT socket on the right
rear side of your TV.
Do not connect the TV to the mains supply until you have
completed all the connections.
GB-14
USB
USB Cable
(not included)
Portable
Hard Disk
I/O POWER ON/OFF switch at the bottom of the
buttons to select DMP and then press the OK button or
OR
RF coaxial cable
(not included)
COMMON INTERFACE
ANT 75 Ω
5V 50mA/Output
Adapter