U-Line H-1075 Operating Instructions

π H-1075
20" VACUUM SEALER
SAFEty PRECAUtIONS
to insure safe operation, the operator should be familiar
with the pinch points and a possible burn hazard near
the seal jaw area. Warning stickers mark the location of
these hazards.
Do not wear neckties, jewelry or loose clothing when
operating the H-1075.
Do not operate, troubleshoot or maintain the H-1075
under the influence of any drug or alcohol.
Always observe all safety warnings and notices on the
machine and in this manual.
DO NOt use flammable or toxic cleaning fluids such as
gasoline, benzene or ether.
CAUTION! Keep hands, fingers and flammable
objects out of the seal jaw area. If a foreign
object is caught between the jaws, turn main
power switch to OFF immediately to prevent
possible burns.
PAGE 1 OF 4
1-800-295-5510
uline.com
OvervIew
CONtROlS
MAIN POWER SWItCH – turns power off and on.
FOOt SWItCH – Controls vacuum cycle and initiates
seal cycle.
HEAt tIMER – Controls heating time. to increase heat,
turn heat timer knob clockwise. to decrease, turn knob
counterclockwise. timer is set in seconds – 10 seconds
maximum.
COOl tIMER – Controls amount of time that pressure
bar remains closed for cooling. to increase cool time,
turn cool timer knob clockwise. to decrease, turn knob
counterclockwise. timer is calibrated in increments of
1/10 minute.
lED INDICAtORS ON HEAt/COOl tIMERS:
• UNlIt: timer is not active.
• SOlID COlOR: timer is active.
• FlASHING: timer has timed-out.
0614 IH-1075