Advertisement
Step8 Route The Cable
1)Put the clip tied on the weight pin leash onto the Top
Plate(#41) as shown, next connect the Cable(#44) to
the Top Plate(#41).
2)Route the Cable(#44) up and over the two Pulleies A
(#23).then secure them to the Main Upright(#1) using
two Allen Bolts(#51) M10×45
two Nylon Locknuts(#62) M10
3)Route the Cable(#44) down and under the Pulley B
(#23),then secure them to the Main Upright(#1) using
one Shoulder Bolts(#55) M10×50
one Nylon Locknuts(#62) M10
4)Connect the looped end of the Cable(#44) to the Cam
(#7), secure it using one Screw(#89) as shown below.
5)Adjust the tension of the Cable (#44) using the Jam
Nut as shown below.
6)Make sure that the cable is in grooves of all pulleies
then fully tighten all bolts and nuts .
7)Select an approprate weight with the weight pin.
C lip
1
2
To p pla te
1 3
four Washers(#60)
two Half-pulley Covers(#71)
Φ
11× 20×1.5
Φ
Ja m Nu t
Advertisement
