Mechanical Disassembly - Sanyo DP42841 Service Manual

CAUTION:
This LCD TV uses several different kinds of screws. Using the correct screw is necessary to prevent damage. Lead wires must
be redressed to their previous locations after servicing. The Earth sheet and gasket are provided to prevent interference to
other radio and television receivers. The Earth sheet and gasket should be returned to its previous position after servicing.
STAND REMOVAL
Position TV face down on a padded or cushioned surface
to protect the screen and finish.
Remove 4 screws (B: 6x12) to take the stand off.
BACK CABINET REMOVAL
Remove 16 screws to take the Back Cabinet off.
(C:3x10, 12 pcs; D:4x8, 4 pcs)
ANALOG BOARD AND
MAIN (DIGITAL) BOARD REMOVAL
Remove 5 screws (C: 3X10) to take the Analog Board and
the Main (Digital) Board off.
POWER UNIT REMOVAL
Remove 6 screws (C: 3X10) to take the Power Unit off.
KEY SW Unit

MECHANICAL DISASSEMBLY

Power Unit
C
C
C
C
C
C
C
KEY SW BOARD REMOVAL
Remove 2 screws (C:3x10) to take the KEY SW board off.
RC LED BOARD REMOVAL
Remove 1 screw (C: 3x10) to take the RC LED board off.
Main(Digital) Board
C
C
C
C
C
C
C
Analog Board
– 6 –
Screws for
C
mounting stand
D
B
C
C
RC LCD Board
C