Tool Storage - Titan 1.866.345.8484 Operation Manual

Foot Replacement
When it is necessary to replace a foot on the Auto-Spreader follow these
steps:
1. Close the feet. The center foot (6) should be aligned with the outside
feet (2 and 3). See fi gures 5 and 6.
2. Loosen the two fl at head Allen screws (1,4) on the bottom of the foot
being replaced.
3. Remove old foot and position new foot in its place.
4. Tighten the two fl at head Allen screws.
Note: It is very important that the fl at head Allen screw be properly tight-
ened. The required torque value is 40 ft. lbs.

Tool Storage

1. Wipe the tool clean with a cloth or paper towel.
2. Close the feet.
Note: The Auto-Spreader should be kept in the ready position when not
in use; feet closed. See fi gure 5.
3
Feet
Closed
5
Figure 5
2
6