Disassembly Instructions - Titan 1.866.345.8484 Operation Manual

Assembly/Disassembly Instructions
The Auto-Spreader™ HS10K is delivered assembled and ready to use.
If it is necessary to disassemble the Auto-Spreader for repairs, follow
the assembly instructions carefully when re-assembling. Failure to follow
these instructions may damage one or more of the components. If any
of the Auto-Spreader components are damaged, please contact your
Fastorq representative before re-assembly.
All numbers in parentheses are referenced in fi gure 6 and the Parts List
on page 7.
Should it become necessary to disassemble the Auto-Spreader, follow
these steps:
Note: Before disassembling the tool, mark the position of the cylinder in
reference to the housing.
1. Close the feet by retracting the center foot until it is aligned with the
outside feet.
2. Position the Auto-Spreader on its side. The side with the dowel pin (7
) should be facing up.
3. Insert a socket head cap screw or any hardened screw with #8-32
threads and about 2" long in the hole and screw it in the dowel pin inside
the hole.
SUPERIOR BOLTING SOLUTIONS SUPERIOR BOLTING SOLUTIONS

Disassembly Instructions

9
1.866.345.8484 1.866.345.8484
TITAN TITAN
TI TI
www. www. .com .com