Operation Important: Do not operate the tool before reading these instructions The Auto-Spreader™ HS10K is designed for spreading and lifting. It is a small, light and powerful precision tool. It generates 10,000 lbs. of spreading force by using hydraulic power. It is extremely versatile, and can be used wherever lifting power is needed.
SUPERIOR BOLTING SOLUTIONS SUPERIOR BOLTING SOLUTIONS 1.866.345.8484 1.866.345.8484 Note: When using the Auto-Spreader for fl ange spreading, it is recom- mended that two Auto-Spreaders be used. Place the fl ange spreaders on opposite sides of the fl ange for even spreading. See fi gure 1...
Figure 2 Red Mark Safety Tips • Always wear the appropriate protective equipment, such as safety glasses and gloves. • Always use safety blocks under any load being lifted with the tool, where possible. See fi gures 3 & 4. •...
SUPERIOR BOLTING SOLUTIONS SUPERIOR BOLTING SOLUTIONS 1.866.345.8484 1.866.345.8484 Figure 4 Safety Blocks on Flange Maintenance Treat the Auto-Spreader like any other precision tool. Keep it clean and free from moisture. Simply wipe it down with a cloth or paper towel after use.
Foot Replacement When it is necessary to replace a foot on the Auto-Spreader follow these steps: 1. Close the feet. The center foot (6) should be aligned with the outside feet (2 and 3). See fi gures 5 and 6. 2.
SUPERIOR BOLTING SOLUTIONS SUPERIOR BOLTING SOLUTIONS 1.866.345.8484 1.866.345.8484 Parts List Item Part # Description FHCS08-13x20 1/2"-13 Flat Head Allen Bolt A95055L Left Jaw A95055R Right Jaw FHCS07-14X16 7/16"-14 Flat Head Allen Bolt A95050 Center Jaw B99050 Piston DP04X20PO Dowel Pin...
SUPERIOR BOLTING SOLUTIONS SUPERIOR BOLTING SOLUTIONS 1.866.345.8484 1.866.345.8484 Assembly/Disassembly Instructions The Auto-Spreader™ HS10K is delivered assembled and ready to use. If it is necessary to disassemble the Auto-Spreader for repairs, follow the assembly instructions carefully when re-assembling. Failure to follow these instructions may damage one or more of the components.
4. Engage the screw using a pry bar and pull it out 1/2”. The dowel pin should come out along with the screw. 5. Extend the cylinder to the maximum extension mark on the piston (6). 6. Pressurize the cylinder to 2,000 PSI or so. 7.
Page 12
SUPERIOR BOLTING SOLUTIONS SUPERIOR BOLTING SOLUTIONS 1.866.345.8484 1.866.345.8484 Figure 7 7. Insert the fl at head Allen screws (4) in the screw holes on the center foot, and tighten them with a 1/4" Allen wrench to 25-30 ft. lbs. 8. Screw the adapter (10) into the piston (6) all the way until the shoulder on the adapter touches the top of the piston.
12. Release the hydraulic pressure from the cylinder and the center foot will retract. 13. Install the dowel pin (7) in the hole on the side of the housing (8), use a hammer if necessary. The dowel pin will ride in the slot on the side of the piston (6), if everything is properly assembled.
SUPERIOR BOLTING SOLUTIONS SUPERIOR BOLTING SOLUTIONS 1.866.345.8484 1.866.345.8484 Trouble Shooting Table Problem Possible Causes Possible Solutions 1. Insuficient hydraulic Cylinder won't 1. Check for sufficient supply pressure and flow cycle in and out of hydraulic oil 2. Quick disconnect not 2.