Installation; Connecting The Monitor - LG FLATRON LCD 575MS User Manual

Connection to any IBM
VGA PC compatible
system

Connecting the Monitor

To set up the monitor, ensure that the power is turned off to the
monitor, computer system, and other attached devices, then follow
these steps:
1.
Place the monitor in a convenient, well-ventilated location near your
computer.
2.
Power off both the monitor and Computer.
3.
Slightly press and pull the latch on Stand cover.
4.
Connect the end of monitor signal cable to the connector
panel of your monitor throught the slot and cable holder on Stand(see
Figure1). Connect the other end to the 15-pin connector on the rear
panel of the computer and tighten the screws. Be sure the signal cable
aligns with the 15-pin connector.
5.
Connect the plug from the AC adapter into the base of the monitor.
Connect one end of the AC power cord to the AC adapter
other end to a properly grounded AC outlet that is easily accessible
and close to the monitor.
6.
After connecting cables, put stand cover correctly into the holes
unders stand. If securely connected, you can hear click sound from the
latch.
7.
Power ON the PC, then the monitor.
8.
If you see the NO SIGNAL message, check the signal cable and
connectors.
9.
After using the system, power OFF the monitor, then the PC.
Note :
If you see the "OUT OF RANGE" message, check to make sure your system is
set to one of the factory preset modes (see page A13), or is set to a resolution and
refresh rate within the specification limits of this monitor.
D-15P
Signal Cable
A4
4
1 2
3
AC adapter
Figure 1.

Installation

1
at the rear
2
3 and the
Latch
Stand cover
4
Power Cord