Olympus FE-320 Instruction Manual page 48

When you get an error message on the camera...
Monitor indication
q
CARD ERROR
q
WRITE PROTECT
>
MEMORY FULL
q
CARD FULL
L
NO PICTURE
r
PICTURE ERROR
r
THE IMAGE
CANNOT BE
EDITED
CARD-COVER
OPEN
g
BATTERY EMPTY
CARD SETUP
CLEAN CARD
FORMAT
MEMORY SETUP
POWER OFF
MEMORY FORMAT
NO CONNECTION
NO PAPER
NO INK
48
Downloaded From camera-usermanual.com Olympus Manuals
EN
Possible cause
There is a problem with the
card.
Writing to the card is
prohibited.
The internal memory has no
available memory and
cannot store any new data.
The card has no available
memory and cannot store
any new data.
There are no pictures in the
internal memory or on the
card.
There is a problem with the
selected picture and it
cannot be played back on
this camera.
Pictures taken by other
cameras or previously
edited or corrected pictures
cannot be edited or fixed.
The battery/card
compartment cover is open.
The battery is empty.
The data in the card cannot
be read. Or, the card is not
formatted.
SET OK
There is an error in the
IN
internal memory.
SET OK
The camera is not
connected to the computer
or the printer correctly.
There is no paper in the
printer.
The printer has run out of
ink.
Corrective action
This card cannot be used. Insert a new card.
The recorded image has been protected
(read-only) on a computer. Download the
image to a computer and cancel the read-
only setting.
Insert a card or erase unwanted data. Before
erasing, backup the data of important
pictures using the card, or download such
pictures to a computer.
Replace the card or erase unwanted data.
Before erasing, download important pictures
to a computer.
The internal memory or the card contains no
pictures.
Record pictures.
Use image processing software to view the
picture on a computer. If that cannot be
done, the image file is damaged.
Use image processing software to edit the
pictures.
Close the battery/card compartment cover.
Charge the battery.
• Select [CLEAN CARD], and press .
Remove the card and wipe the contact
area with a soft dry cloth.
[YES] and press .
• Select [FORMAT]
All data on the card is erased.
Select [MEMORY FORMAT]
press . All data in the internal memory is
erased.
Disconnect the camera and connect it again
correctly.
Load some paper into the printer.
Replace the ink cartridge in the printer.
[YES] and