Panasonic KX-TG6411C Operating Instructions Manual page 23

TG64xxC(e).book Page 23 Monday, December 22, 2008 4:02 PM
Feature Feature
code
Play all msg.
{3}{2}{4}
(msg.: messages)
Play new msg.
{3}{2}{3}
(msg.: messages)
Pre-recorded
{3}{0}{4}
(Reset to pre-
recorded greeting)
Record greeting
{3}{0}{2}
Recording time {3}{0}{5} {1}: 1min {2}: 2min
{3}{0}{6} <111>
Remote code
{2}{1}{1} {2}–{7}: 2–7 rings <4>
Ring count
{1}{1}{2} {1}: <English>
Voice prompt
(Change language)
*1 If "System setting" column is checked, you do not need to program the same item
using another handset.
*2 If you subscribe to a Call Display service and want to view the caller's information
after lifting up the handset to answer a call, turn off this feature.
*3 The handset can display the Internet address where you can download the
operating instructions or get further information for this product, using your
computer.
*4 Turn this feature off if you prefer not to hear key tones while you are dialing or
pressing any keys, including confirmation tones and error tones.
*5 If you subscribe to a distinctive ring service, select a tone (tone 1 to 3). If you select
a melody, you cannot distinguish lines by their ringers.
*6 If you select one of the melody ringer tones, the ringer tone continues to play for
several seconds even if the caller has already hung up. You may either hear a dial
tone or no one on the line when you answer the call.
*7 When the ringer volume is turned off, ~ is displayed and the handset does not ring
for outside calls.
However even when the ringer volume is set to off, the handset rings at the low
level for alarm (page 24), intercom calls and paging (page 40).
*8 The flash time depends on your telephone exchange or host PBX. Contact your
PBX supplier if necessary.
*9 Generally, the line mode setting should not be adjusted. If S is not displayed
when another phone connected to the same line is in use, you need to change the
line mode to "A".
*10This feature allows the unit to automatically adjust the date and time setting when
caller information is received. To use this feature, set the date and time first.
Setting code
–
–
–
–
{3}: <3min>
{0}: Greeting only
{0}: Toll saver
{2}: Français
Programming
System Page
*1
setting
– 34
– 34
33
r
33
r
36
r
34
r
36
r
13
r
23