Advertisement
E T C S e t u p G u i d e
Co nn ect i on an d S et up
Connect Base Station Receiver
The receiver includes a USB type B connector and an Ethernet connector (IEEE 802.3af)
on the front of the unit for connection to the console (USB) or to a switch in your Net3
network.
Push
C A U T I O N :
U S B
When the base station is connected directly to a console by USB type B, the RFR is powered by and
controls only the console the base station is connected to. ETC supplies a 1.8m (6 ft.) USB cable for
base station connection to a console or USB hub. The maximum distance between products is 5m (16
ft.).
Direct USB Mode:
To connect the Remote to a console directly, you need to use Direct USB mode.
Step 1:
Step 2:
Step 3:
Base USB Mode:
To connect the remote to a base station connected to a console via USB, you need to use Base USB
mode.
Step 1:
Step 2:
N o t e :
Step 3:
E t h e r n e t
For use with the Eos console, the base station may connect directly to the Ethernet port which is IEEE
802.3af. Both data and power are provided through this connection.
For use with a Congo, Congo jr, Eos,or Ion, the base station can connect Ethernet through a powered
Ethernet switch. If a powered Ethernet switch is not available, the base station can connect through a
ethernet switch to the console and from a USB power source to the USB type B connection on the base
station for power.
N o t e :
Net 3 Radio Focus Remote Set up Guide
You may utilize either the Ethernet connection or the USB connection for data to
the console, but not both.
With the remote power off, press and hold the [.] button. Continue pressing [.] and power
up the remote. The remote will boot into the Console Selection List.
In the Console Selection list, select {Direct USB} mode.
The remote will prompt you to reboot. Reboot the remote. It will start up in Direct USB
mode.
With the remote power off, press and hold the [.] button. Continue pressing [.] and power
up the remote. The remote will boot into the Console Selection List.
In the Console Selection list, select {Base USB} mode.
Base USB mode will not appear as an option unless the remote discovers a base
station connected via USB to a console and set to the same frequency as the
remote.
The remote will prompt you to reboot. Reboot the remote. It will start up in Base USB
mode.
For single base station use, no configuration is needed if defaults are used. For
multiple base stations, custom configurations, and connection issues, further
configuration will be needed.
Net3 Radio Focus Remote
Page 2 of 7
Elect ronic Theat re Cont rols, Inc.
Advertisement
