Getting Started - Whites MXSPORT User Manual

Getting Started with MX Sport
1. Press the power ON button. Upon initial power up, the detec-
tor defaults to the Coin and Jewelry program.
2. Sweep the search coil from side to side, keeping it level and
close to the ground. Overlap each search pass by at least
50%.
3. Once a target is detected, indicated by a consistent beep,
sweep several passes over the target center and note the
display identification and target depth.
4. If the target indicates dig worthy, press and hold the Pinpoint
button (√/X). If tapped, the pinpoint button will lock in the Pin-
point mode. After pinpointing remember to tap the pinpoint
button once more to return to Search mode.
5. When using MX Sport's DD search coil, the pinpoint spot is
an imaginary line through the center of the search coil. It is
important to determine where this detection line begins and
ends on the coil. When using an optional concentric search
coil, the pinpoint spot is in the center of the search coil
6. Sweep the target area slowly in an "x" pattern. The strongest
beep and shallowest depth indicates target center.
7. Practice with a visible object above ground, moving back and
forth over the target.
8. Use care in digging properly for the terrain. Fill in all holes
and discard any trash found in the proper receptacle. By not
leaving trash and unsightly holes behind you, open areas will
continue to be available for you and others to metal detect.
Controls
The MX Sport operates in either Search or Options mode. The
detector will continue to provide audio feedback when in Options
mode, but the display will be used to show options rather than
target information.
6