4-4.3 I/O Device Configuration - Supero P8SGA User Manual

P8SGA User's Manual
4-4.3
I/O Device Configuration
Onboard Serial Port1/Onboard Serial Port2
This setting allows the user to set the address and the corresponding IRQ
for the Serial Port1 and Serial Port 2. The options are Disabled , 3F8/
IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, and Auto. The default setting for Serial
Port1 is 3F8/IRQ4 and the default for Port 2 is 2F8/IRQ3.
UART Mode Select
This setting allows the user to select the UART mode for the BIOS. The
options are IrDA, ASKIR and Normal.
RxD, TxD Active
This allows the user to change the settings for the RxD, TxD Active
function. The options are Hi, Hi, Hi, Lo, Lo, Hi, and Lo, Lo.
IR Transmission Delay
If Enabled, the transmission of IR (infrared) signals will be delayed. The
options are Enabled and Disabled.
UR2 Duplex Mode
This setting set the mode for the UR2 Duplex Mode. The options are Full
and Half.
4-10