Cradlepoint AER3100 User Manual page 53

User Manual / AER3100/AER3150
NEMO
Network Mobility (NEMO) is an Internet standards track protocol defined in RFC 5177. The protocol allows
session continuity for every node in a mobile network as the network moves.
NOTE: NEMO requires a feature license not included with ECM Prime. Go to SYSTEM > Administration > Feature
Licenses to enable this feature.
NEMO requires a service provider, e.g. Verizon Wireless Private Network with DMNR (Dynamic Mobile Network
Routing). Your NEMO service provider will define many of the settings for your NEMO configuration.
Once you have a NEMO service provider and a valid feature license, add networks to the Networks Routed by
NEMO section by first clicking Add. In the popup window, input:
• Network Address - This is the network address that is the destination of the route. This should be set to
the network address at the remote side of the tunnel.
• Netmask - This is the corresponding subnet mask of the network being defined (Default: 255.255.255.0).
The Network Address and Netmask, or subnet mask, together define a range of IP addresses that comprise the
local network you want associated with the NEMO settings.
Network Mobility (NEMO) Settings
Enbable: Enable NEMO.
WAN: Select the WAN(s) to use for the
NEMO connection. An expression such
as "Unique ID is (any)" will allow NEMO
to operate on any WAN, whereas "Type
is LTE" will limit NEMO operation to the
WAN(s) provided by any connected LTE
device(s).
With WAN: Register the NEMO connection
simultaneous with its specified WAN
connection becoming available. If not
checked, will only register the NEMO
connection when needed.
Home IP Address and Home Netmask –
These may be provided by your NEMO
service provider. The IP address is a
placeholder, "dummy" address; any IP address can be used (1.2.3.4 is common).
Home Agent IP Address, Home Agent Password, and Home Agent SPI – Your home agent will be defined by
your NEMO service provider.
Renew Registration – The NEMO network regularly re-registers with the home agent (e.g., every 30 seconds).
Specify the number of seconds between each check-in.
MTU – Override the maximum transmission unit (MTU) of the NEMO tunnel. The TCP
size) is automatically derived from the MTU. Leave blank to rely on Path MTU
©2015 Cradlepoint. All Rights Reserved.
MSS (maximum segment
Discovery.
| +1.855.813.3385 | cradlepoint.com
53