Miele KM 6360 Operating And Installation Instructions page 49

Problem
After the cooktop is ac‐
tivated,  appears in
the timer display for
several seconds.
 flashes in the
timer display and
the cooktop
turns off auto‐
matically.
After turning on the
cooktop,  appears in
the timer display for
several seconds. The
cooking zones don't
heat up.
A burner switches itself
off automatically.
A cooking zone or the
whole cooktop turns off
automatically.
The booster has auto‐
matically switched off
early.
The burner is not work‐
ing in the usual way
with the set power lev‐
el.
Power setting 9 is auto‐
matically reduced if you
select power setting 9
on two linked burners
or extended zones at
the same time.
Frequently asked questions
Possible cause and solution
The system lock or safety lock is activated.
 Deactivate the system lock or safety lock (see
"System lock / Safety lock").
One or more of the sensor buttons are covered, for
example by fingers, food boiling over or by an object.
 Clean off any dirt or remove the object (see "Safe‐
ty shut-off").
The cooktop is in demo mode.
 Deactivate demo mode (see "Programming").
A burner might have been operated for too long.
 You can use the burner again by switching it back
on (see "Safety switch-off").
The overheat protection was triggered.
 See "Overheat protection."
The overheat protection was triggered.
 See "Overheat protection".
The overheat protection was triggered.
 See "Overheat protection".
Operating both zones at power level 9 would exceed
the permitted maximum power for the cooktop.
 Use another burner that is not linked.
49