Related Manuals for V-Tec DT-DJ5A
Summary of Contents for V-Tec DT-DJ5A
-
Page 1: User Manual
DT-DJ5A Audio Phone User Manual Read this manual carefully before using the product, and keep it well for future use. ... -
Page 3: Parts And Functions
1. Parts and Functions Microphone Speaker Unlock button Talk button Unlock 2nd/Intercom button Indicator Talk volume Tone volume controller controller Side View Key functions Speaker Send out voice from the visitor. Microphone Receive voice from the user. Unlock button Press to release the door. Talk button Press to communicate hands free with visitor During calling/talking state, press Unlock 2nd button to re-... -
Page 4: Terminal Descriptions
2. Terminal Descriptions DIP2 DIP1 L1, L2 L1,L2:Bus terminal. DIP1(Bit1~6):Used to User Code setting. DIP2(Bit1~3):Used to Slave Monitor Address or Extended Address setting. 3. Unit Mounting 1). Fix 2 screws to the wall at a appropriate height; 2). Connect the system correctly; 3). -
Page 5: Setup Instructions
4. Operation Instructions 1) Door release function: When visitor calls from outdoor station, the monitor rings, press Talk button to talk with the visitor, then press the Unlock button to open the door. If the system connect 2 locks, press Unlock 2nd button to open the second door. 2) Intercom call: When the monitor is in standby mode, press Unlock 2nd button/ Intercom button to activate the intercom call, all monitors connected to the system will ring at the same time. - Page 6 Bit state User Code Bit state User Code Bit state User Code Code=6 Code=17 Code=28 3 4 5 3 4 5 3 4 5 Code=7 Code=18 Code=29 3 4 5 3 4 5 3 4 5 Code=8 Code=19 Code=30 3 4 5 3 4 5 3 4 5 Code=9...
-
Page 7: Ring Tone Setting
5.2.2 When Bit-3 of DIP2 set to ON, the Bit-1~2 of DIP2 and Bit-1~5 of DIP1 are used to extended address setting: DIP2 state DIP1 state User Code DIP2 state DIP1 state User Code Code=1 Code=65 3 4 5 3 4 5 Code=2 Code=66 3 4 5... -
Page 8: Specification
2). Press and hold Talk button in standby mode to enter the state of ring tone setting, and then each time you press Unlock 2nd button to replace a group of ring tones. Four groups ring tones cycle: press Unlock 2nd press Unlock 2nd press Unlock 2nd Group1...