Connecting The Composite Video Signal To The Monitor; Connecting The Y/C (S-Vieo) Signal To The Monitor; Connecting Audio To The Monitor; Connecting The Analog Vga Signal To The Monitor - Bosch MON152CL Instruction Manual

Table of Contents

Advertisement

MON152CL | Instruction Manual | Installation
2.4
Connecting the Composite Video Signal to
the Monitor
There are two(2) BNC connectors located on the rear of the
monitor for composite video input and two(2) BNC
connectors for composite video outputs(Fig. 8)
NOTE: All video input are active loop-through. The
impedance is automatically set to 75 ohm by the input of the
signal on the input connector, while operation in a single
connection mode (Fig. 6). If a cable is also connected to the
output connector, the video signal can be passed on to
another monitor connected to it via the active loop-through
function. Up to three(3) monitors may be connected in this
manner(Fig. 7)
NOTE: To select between Input 1 and Input 2,push Input
(Fig. 1 item1) located on front of the monitor.
2.5
Connecting the Y/C (S-video) Signal to
the Monitor
There is one(1) min-DIN type connector for the S-video
(Y/C) input (as in Fig. 5 and Fig. 8).
3
4
1
2
Fig. 5 Y/C Connection Pinout
Video Camera
From Video Output
Bosch Security Systems | 22 September 2003
1. GND
2. GND
3. Y-signal IN or OUT
4. C-signal IN or OUT
AUDIO
VIDEO
VIDEO
I N
I N
I N
I N
OUT
OUT
O UT
O UT
Y/C
PC IN
R
L
Fig. 6 Single Monitor Configuration
AUDIO
VIDEO
VIDEO
I N
I N
I N
I N
O UT
O UT
Y/C
PC IN
OUT
OUT
R
L
Fig. 7 Multiple Monitor Configuration
NOTE: Both Y and C inputs are terminated with 75 ohm.
2.6

Connecting Audio to the Monitor

There are two(2) sets of audio connectors (Fig. 8); One set
of audio input (R) and input (L); the second set is audio
output (R) and audio output (L).
Audio input (L)
Audio input (R)
Audio input (R)
Audio input (L)
Fig. 8 Connectors-Exploded view
2.7

Connecting the Analog VGA Signal to the Monitor

There is one (1) 15-pin D-sub connector ( Fig. 9 ) for one analog
VGA input. Refer to Fig. 2 , Item 13 for location.
Fig. 9 Analog VGA Connector
2.8

Ventilation

To prevent overheating, ensure that the ventilation openings on
the rear of the monitor are not covered.
Video Camera
AUDIO
VIDEO
VIDEO
I N
I N
I N
I N
O UT
O UT
Y/C
PC IN
OUT
OUT
R
L
EN | 11
Video 2 input
Video 1 input
Y/C input
Analog VGA input
Video 1 output
Video 2 output
VCR
AUDIO
VIDEO
VIDEO
I N
I N
I N
I N
O UT
O UT
Y/C
PC IN
OUT
OUT
R
L

Advertisement

Table of Contents
loading

Table of Contents