Setting The Buzzer; Drawer Circuitry - Epson TM-T88IV Technical Reference Manual

Drawer Circuitry

Setting the Buzzer

You can set so that the buzzer beeps when the drawer is opened.
The buzzer setting is performed by setting the DIP switches for the buzzer and specifying
connector pin numbers to which a command outputs a pulse signal.
DIP
Specified connector pin
switch
1 Drawer kick out connector pin 2
2 Drawer kick out connector pin 5
Since the buzzer drive signal and the cash drawer drive signal are common in the printer,
do not use the same connector pin numbers to output the signal for the buzzer and the
cash drawer.
For detailed information about ESC/POS commands, see the TM-T88IV Specification
(ReStick Model).
56
Drawer kick-out connector
Printer side
With shielded
Drawer open/close switch
User side [Drawer kick-out side]
ON OFF
Buzzer does not
Buzzer beeps.
beep.
Buzzer does not
Buzzer beeps.
beep.
Drawer kick-out solenoid
Initial setting
ON
OFF