For Parallel Interface/Lan/Wireless Lan Interface - Epson TM-T88IV Technical Reference Manual

For Parallel Interface/LAN/wireless LAN Interface

DIP switch bank 1
SW
1-1 Auto line feed
1-2 Receive buffer capacity
S e l e c t s p a p e r s e n s o r s t o
1-3 o u t p u t p a p e r- e n d s i g n a l s
(default value of a command)
1-4 Error signal output
1-5 ∼
Undefined
1-8
*1: When using the recommended liner-free label, the roll paper near-end sensor is disabled.
DIP switch bank 2
SW
2-1 Handshaking (BUSY condition)
R e s e r ve d ( D o n o t c h a n g e
2-2
setting)
2-3
Selects print density/
Recommended liner-free label
2-4
Setting the release condition
of the receive buffer BUSY state
2-5
(This function is effective when
DIP switch 1-2 is set to off.)
2-6
Reserved
(Do not change settings)
2-7
IF pin 31 reset signal (Do not
2-8
change settings)
• For DIP switch 2-1 (BUSY condition), see also
• Do not change the setting of DIP switches 2-2, 2-6, and 2-7. Otherwise, the printer may
38
Function
Always enabled
Function
Receive buffer full
See
2-3/2-4)" on page
Releases the BUSY
s t a t e w h e n t h e
remaining capacity
of the receive buffer
reaches 138 bytes.
not operate normally.
ON
Always disabled
45 bytes
R o l l p a p e r
sensor enabled, roll
Disabled
p a p e r
sensor enabled
Disabled Enabled
—
ON
• Offline
• Receive buffer full
Fixed to OFF
"Selecting the Print Density (DIP Switch
40.
Releases the BUSY
s t a t e w h e n t h e
remaining capacity
of the receive buffer
reaches 256 bytes.
Fixed to OFF
Fixed to ON
"Selecting the BUSY Status" on page
Factory
OFF
setting
OFF
4 KB OFF
e n d
OFF
n e a r- e n d
*1
OFF
— OFF
Factory
OFF
setting
OFF
OFF
ON
OFF
OFF
ON
41.