End Button Function On Pendant; Handset On Base Unit Works On An Analogue Line During Power Failure; How To Recall Pin Code - Lifemax 1225 User Manual

END button function on pendant

During TALKING MODE and/or SOS CALLING MODE, press the END
button on pendant to disable the TALKING/CALLING activity.
In idle mode, press the END button to check the battery capacity, it will
emit a voice saying "BATTERY IS OK", or a low battery alert tone will
emit automatically at 1 minute intervals
Handset on base unit works on an analogue line during
power failure
Only the base unit will work on an analog line in case of power failure and
no batteries.
1. When the external party calls the unit, the normal melody sounds,
pick up the handset to answer the call.
2. Make a call from the base by picking up the handset; the dialed
number will be displayed on the LCD.
3. Mute function is available.
4. In case of power failure, the speaker, pendant, M1/M2 direct
memory, SOS function and 0~9 two touch memory on base will
stop working.
5. If power fails when talking with the pendant, the pendant will be
automatically switched off and it will put on hold by the base for 30
seconds
conversation by picking up the handset within 30 seconds,
otherwise the external line will automatically disconnect after 30
seconds.

How to recall pin code

While the base is in Standby mode:
1. Press
"*1006", LCD displays "SW VERSION"
2. Then press "UP" or "Down" button to select" EEPROM SET"
3. Then press
4. Then input digit button"0", then press"0"again for a little longer.
LCD displays "A", then input "1" and"2", LCD displays"B0A O
12D=XXXX"
(XXXX stands for the pin code you have stored, but had forgotten).
while displaying "LINE IN USE". You can resume the
button once, LCD displays "CALL LOG", then input
button to confirm, LCD displays"B01 O 01D=0000"
25