Table of Contents
Advertisement
Other SOS operations in the pendant are the same as in the base.
Room Monitor Operation:
A. When the room monitor function is set "ON" and external line calls in, a
ring sound can be heard in the base.
1. When the pin code is "9999", the caller can pick up the line
automatically without a code to monitor the end user in both base
and pendant 1, in the hands free mode.
2. When the pin code is any other 4 digits except "9999", the voice
prompt announcement is activated "Please enter the PIN code" and
the call party must enter the code.
**After entering the correct code the external call party can monitor
the end user via both the base and pendant 1, in the hands free mode.
**After entering the wrong code or without entering the code, the unit
will end the call and go into "off mode" after 10 seconds.
3. The end user can use the phone when room monitor set "ON", but
when the external call party monitors the end user, other phone
buttons will be locked, only SOS function, off-hook and hands free
are still active.
B. During ECI function (Emergency Call Interruption):
1. The external call party can control the unit with DTMF tone as
below:
** Mute the microphone– with digit / number 6
** Speaker volume off – with digit / number 4
** Normal hands free – with digit / number 5(This one is default
mode
2. 0nly the external call party can end the call; cancellation by end
user side can be done only through:
1) pressing SOS button to exit room monitor mode and dial out SOS.
2) Picking up handle to talk under room monitor mode.
3) on-hook or pressing hands free key to exit from room monitor
mode.
4) Removing the power line and phone line.
3. When room monitor is activated, press SOS button on the unit:
the SOS number will be dialed out automatically after disconnecting
the ECI call. The owner of the SOS number can control the unit by
pressing digit/number 4/5/6. The operation then continues as above.
23
Advertisement
Table of Contents
