Table of Contents
Advertisement
When room monitor is activated, if the end user presses the red
button from the pendant, the pendant will exit room monitor mode,
pressing the red button again it will dial out automatically after
disconnecting the ECI call. The owner of the SOS number can
control the unit by press digit/number 4/5/6. The operation is as
above.
Note: When room monitor is activated, press red key on base or
pendant and the owner of the SOS number cannot control the phone
by pressing digital number 4/5/6
4. It will make a howling noise if the pendant is within 1 metre away
from the base, pressing the red button on the pendant can stop the
noise because the pendant has exited room monitor mode, but the
base is still in ECI mode. In ECI mode, when external line calls in,
pick up the receiver to receive ECI phone call, hang up the handset
or press hands free key to terminate ECI function.
Pendant power on/off operation
The pendant power is preset to OFF ex-factory, to switch it ON, just press
the red button once
1.
To set the pendant (OFF), press the red button for 10 seconds to
switch the pendants power off. A sound can be heard to confirm.
2.
When Pendant is off, press the red SOS button once to switch on.
A sound can be heard to confirm.
Note: The pendant will come ON automatically when put on the
charger.
Pendant battery alert
To check the battery capacity, you just need to press END button on the
pendent and the pendant will say "BATTERY IS OK", to indicate the
battery capacity is running ok.
When battery is almost depleted, a voice alert saying "CHARGE
BATTERY NOW" will automatically speak at 1 minute intervals until
returned to the charging unit
When the battery is running low, a voice alert says "CHARGE BATTERY
SOON" this will automatically speak every 1 minute.
24
Advertisement
Table of Contents
