Program The Esc - Carson X8E Chassis 500409015 Instruction Manual

6S – Program the ESC
1. Programmable items (the italics texts in the form are the default settings)
programmable items for dragster 4s
Programmable
G
item
1. Running mode
2. Drag brake force in neutral
position
3. Low voltage cut-off threshold
4. Start mode (punch)
5. Maximal brake force
2. Explanation for each programmable item
Running mode
With "Forward with Brake" mode, the car can go forward and brake,
but cannot go backward, this mode is suitable for competition.
"Forward/reverse with brake" mode provides backward function,
which is suitable for daily training.
But for ESC, "Forward/reverse with brake" mode uses the "Single-
click" method to make the car go backward.
"Forward/reverse" mode uses the "Single-click" method to make the
car go backward. When you move the throttle lever from forward
zone to backward zone, the car will go backward immediately.
Drag brake force in neutral position
Set the amount of drag brake applied at neutral throttle to simulate
the slight braking effect of a neutral brushed motor while idle speed.
Low voltage cut-off
The function prevents the lithium battery pack from over discharging.
The ESC detects the battery's voltage at any time. If the voltage is
lower than the threshold for 2 seconds, the output power will be redu-
ced 70%, 10 seconds later the output will be completely stopped, and
the red LED flashes in such a style: " ** , ** , ** " (double flashes).
42 CARSON X8E Chassis 500409015 / 500409016
1 2 3
Forward Forward/ Forward/
with backward backward
brake with
brake
0 % 5 % 10 %
Nonpro- 2.6 V / 2.8 V /
tection Zelle Zelle
Level Level Level
1 2 3
(Soft)
25 % 50 % 75 %
Programmable value
4 5 6
20 % 40 % 60 %
3.0 V / 3.2 V / 3.4 V /
Zelle Zelle Zelle
Level Level Level
4 5 6
100 %
Acceleration mode (also called "Punch")
Select from "Level 1" to "Level 9". A higher number means more
aggressive acceleration.
Maximum Brake Force
The ESC provides proportional brake function. The brake force is rela-
ted to the position of the throttle stick. Maximum brake force refers
to the force when the throttle stick is located at the top point of the
backward zone. A very large brake force can shorten the brake time,
but it may damage the gears.
3. Program the ESC with the "SET" button
You'll find the instructions on the next page in the flowchart.
4. Reset all items to default values
At any time when the throttle is located in neutral zone (except in the
throttle calibration process or ESC program mode), you can hold the
"SET" key for over 3 seconds. The red LED and green LED will flash at
the same time, which means each programmable item has be reset to
its default value.
7 8 9
80 % 100 %
Level Level Level
7 8 9
(Aggresiv)