Air Filter - Echo SRM-280U Operator's Manual

Hide thumbs Also See for SRM-280U:

Table of Contents

SRM-280U

Air Filter

Level 1.

Parts Required:

REPOWER

1. Close choke (COLD START [

dirt from entering the carburetor throat when the air filter is

removed. Brush accumulated dirt from air cleaner area.

2. Remove air filter cover and air filter retainer from inside

cover. Brush dirt from inside cover.

3. Replace filter if it is damaged, very dirty, or the rubber sealing edges are deformed.

4. Remove foam pre-filter and air filter and clean as indicated

below:.

Foam Pre-filter

• Clean foam filter in water/detergent solution and rinse with

clean water.

• Wrap the filter in a clean, dry cloth and squeeze (do not

wring) dry. Allow to dry completely before reuse. Do not oil.

Dual Layer Air Filter

• Lightly brush debris from filter.

• Soak heavily soiled filters in water/detergent solution to loosen dirt, then brush lightly.

• Rinse with clean water and allow to dry completely before reuse.

5. Place foam pre-filter over raised center and inside outer lip of air filter. Install air filter in air filter case.

6. Install air filter retainer on post in air filter cover, flat side up.

7. Install air filter cover and tighten cover knob securely.

AIR & FUEL FILTER KIT.

]) position. This prevents

MAINTENANCE

X7502310910

Table of Contents