DISPLAY INDICATIONS
TURBO BLOWER ON
TURBO BLOWER
DISCONNECTION
WATER CYCLE
ACTIVATED
PERMANENT INFORMATION
TURBO BLOWER
DRYING SYSTEM
ACTIVATED
NOT ENOUGH
WATER IN THE
TANK
- Clock.
- Battery level: If the voltage decreases to the set level (10,5 V. factory
default), a
blinking display will appear and the equipment will start slowing down
automatically, decreasing the turbo blower speed
The command and control module accumulates the working hours, and after working for
1000 hours,
turns on permanently indicting that the evaporator needs to be replaced.
Note: working hours are either when
the turbo blower or the water pump is on.
- Every time the evaporator is replaced the timer must be set to
By pressing
the turbo blower
By pressing
again the turbo blower
disconnected.
SELF POWER ON OR
SELF POWER OFF
TIME/ TURBO
BLOWER SPEED
LEVELS
AUTO
BATTERY LEVEL
SHORT-CIRCUIT IN THE WATER
PUMP OR IN THE TURBO BLOWER
OR ELECTROVALVE/ CHANGE THE
EVAPORATOR WARNING
progressively
and the pump control system
and the pump control system
.
(zero).
will be activated.
will be