Hide thumbs Also See for PC310:

Advertisement

OWNER'S MANUAL
THE BATTERY
THAT GOES TO
EXTREMES

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PC310 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Odyssey PC310

  • Page 1 OWNER’S MANUAL THE BATTERY THAT GOES TO EXTREMES...
  • Page 2: Mounting Flexibility

    400 charge/discharge cycles to 80% depth of discharge (DOD). A typical starting, lighting and ignition (SLI) battery can do one or the other, but not both. It is either a sprinter or a long distance runner; ODYSSEY batteries will do both — provide short duration high amperage pulse or low rate long duration drains.
  • Page 3: Installation

    INSTALLATIoN Your ODYSSEY™ battery is normally ready to install right out of the box! Measure the battery voltage; if it is 12.65 volts or greater, install; if less, then refer to the charging section. ANY oF THE FoLLoWING WILL VoID YoUR WARRANTY: •...
  • Page 4 **Pulse Current † Can be fitted with brass automotive terminal All batteries available with metal jackets, except PC310, PC535, PC625, 75/86-PC1230, 25-PC1400, 35-PC1400, 34-PC1500, 34M-PC1500, 34/78-PC1500, 65-PC1750, 31M-PC2150 and PC2250 Operating temperature range: -40°C (-40°F) to 45°C (113°F) • -30°C (-22°F) to 40°C (104°F) for PC2250...
  • Page 5 State of Charge (SoC), % 25°C 45°C 65°C Figure 2: ODYSSEY™ Battery OCV vs. SOC As long as the battery has not been charged or discharged for 6 or more hours, Figure 2 can be used to determine the SOC of the ODYSSEY battery.
  • Page 6: Maintenance

    12.18 Volts 11.88 Volts To get long life from the ODYSSEY battery, it is important that the battery is kept near full charge, approximately 12.8 volts. If there are electrical loads during storage, then the negative battery cable should be disconnected or an independent float charger used. Low power 2.0 amp chargers for storage charge will keep a fully charged battery fully charged but cannot recharge if the ODYSSEY battery becomes discharged.
  • Page 7: Winter Storage

    24V BATTERY CoNNECTIoN To power a 24V trolling motor, you will need to connect two ODYSSEY™ batteries in series. As shown in the top illustration, the negative of Battery 1 is wired to the positive of Battery 2. Hook up the positive terminal of Battery 1 to the positive terminal of your trolling motor and the negative terminal of Battery 2 to the negative terminal of the trolling motor.
  • Page 8 Manufacturer’s shipping date. Within the Applicable Warranty Period, the Battery will be replaced free of charge if adjustment is necessary due to defect in material or workmanship (not merely discharged). Simply return the Battery to any authorized ODYSSEY battery dealer with the original receipt for a replacement.

Table of Contents