DISASSEMBLY
Introduction
Before disassembly is started, the antenna
connector cap at the top of the phone has to
be removed to allow full separation. Reason-
able care should be taken during the disas-
sembly and reassembly of the unit in order to
avoid damaging or stressing the housing and
internal components. Ensure that a properly
grounded high impedance conductive wrist
strap is used while
performing these procedures on electronic
units.
Recommended Tools
The following tools are recommended for
use during the disassembly and reassembly
of the phone.
- Anti-Static Mat Kit (0180386A82);
includes:
CAUTION
Many of the integrated circuit devices used
in this equipment are vulnerable to damage
from static charges. An anti-static wrist
band, connected to an anti-static (conduc-
tive) work surface, must be
© 2000 Motorola, Inc.
worn during all phases of disassembly,
repair, and reassembly.
Anti-Static Mat
Ground Cord
Wrist Band
Plastic (bezel stick)Prying Tool
Light guide removal Fixture
Flip Opening Tool
Flex Removal Pliers