Motorola V8160 Service Manual page 28

V8160
Keypad
Command
Description
Entry
19X Multi-Version
20#-24# (not -used)
25X# Sat/Dsat On
26# Sat/Dsat Off
27X# Cdata
28# HITNON
29# HITNOFF
30# LOTNON
Table 8:
Status Display
Displays version corresponding to the two digit option x.
The following table show the valid options for x:
Decimal
00 Call processor
01 CDMA test command document number
02 Date
03 Time
22 DSP mask version
23 DSP patch version
- The call processor (factory version) number in the
format: 00 XXXX
- The CDMA test command document number: 01 XXXX
- The date the build was created in the format: 01JAN96
- The time the build was created in the format: xxyyzz
where xx is the hour, yy is the minute, and zz is the
second.
- The version of the DSP mask xxxxyyyyyyzzzz
where xxxx is the version, yyyyyy is the date, and zzzz is
the device.
Enable SAT/DSAT transponding.
For AMPS mode, the bye following the opcode is the color
code of the SAT frequency that the radio may expect to
receive. The command only uses the narrow phase lock
loop mode and locks only to the frequency selected
(+/- 15 Hz).
Valid color codes for X:
0 = 5970 Hz
1 = 6000 Hz
2 = 6030 Hz
Disable the transponding of Sat/Dsat.
AMPS: Continuous Transmit Data on the reverse Analog
Control Channel.
CDMA: Random Transmit Data (RTD) on the reverse
CDMA channel.
Input Action
0 Start (AMPS) / Variable Rate (CDMA)
1 Full Rate (CDMA)
2 Half Rate (CDMA)
4 Quarter Rate (CDMA)
8 Eighth Rate (CDMA)
9 Stop RTD (AMPS, CDMA)
Tuen on high tone (frequency 1150 Hz +/- 55Hz)
Turn off high tone.
Turn on low tone (frequency 770 Hz +/- 40 Hz)
Result