Test Mode; Handset Commands - Motorola V8160 Service Manual

Test Mode

Also included in the software is a Manual
Test Mode, which allows viewing the ESN,
software version number, and programming
the phone number (NAM).

Handset Commands

Key
*
Toggles the display to the next location (enters data displayed to buffer).
When hit at last program step, the command is terminated (if required,
information may also be programmed into the EEPROM).
If the command relates to a test function with multiple data displays, the *
key is used to pause scanning data or to step through sequential test func-tions.
Entering the * key during a pause time resumes scanning.
CLR/END
Resets the location to presently programmed information (if the command
allows user input).
#
Terminates command without changing any of the programmed informa-tion.
Each command consists of at least two digits entered from the telephone
keypad with the entry terminated using the # key.
For commands that initiate an action that requires a response or that
accu-mulates
error counts, the # key terminates the test.
DIGIT
Enter digit value. If the value to be modified is filled or exceeded, the CLR
must be pressed before more digit selections are allowed. This is valid only if
the command allows user input.
For The Gain and power Phasing handset test commands only
SND
Send into HEX mode. Keys 0-5 enter immediately after the send key are
translated into HEX A-F respectively.
Volume up/
Increments/decrements the current data value. If the maximum value for this
down
data location is exceeded then it is set to zero.
STO
Shortcut to save values and quit test command.
To enter Manual Test Mode:
- 0 0 * * 83786633
(83786633 spells "TESTMODE" on the
keypad).
Table 7:
Function
Identity and Security