Table of Contents
Advertisement
8
1
Installation of the S2Konnect
Unmanaged Switch
The installation of the S2Konnect S-8180T Unmanaged Switches is easy.
The unit may be used for rack, wall or on table installation.
Installation on a Level Surface
To install the S2Konnect Unmanaged Switch on a table or similar, attach rubber feet on each
marked location on the bottom of the device to avoid slipping of the device and scratches on the
surface. After putting in the power cord the green Power LED should light up.
à please place the S2Konnect Unmanaged Switch on a robust level surface that can support at
least 2.5kg (5.5lb) of weight.
Installation on a Wall
To install the S2Konnect Unmanaged Switch on the wall, proceed as follows:
1.
screws.
2.
3.
4.
5.
6.
7.
8.
9.
S2Konnect S-8180T
Attach the brackets at each side of the S2Konnect Unmanaged Switch using the supplied
Hold the S2Konnect Unmanaged Switch against the wall and mark the wall trough the
holes of the brackets.
Drill holes in the wall for the brackets.
Hold the S2Konnect Unmanaged Switch against the wall ensuring that the drilled holes
align with the holes of the brackets.
Insert a dowel (not supplied) to provide better support.
Screw the S2Konnect Unmanaged Switch on the wall using the supplied screws.
Tighten all screws.
Plug in the power cord.
Turn on the S2Konnect Unmanaged Switch.
The green Power LED should light up indicating that the power supply is ok.
Figure 1. Wall Installation
Advertisement
Table of Contents
