Table of Contents
Advertisement
13
The LEDs of the S2Konnect S-8180T Unmanaged Switches have the following meaning:
Marking on
panel
Power
SPD/LNK/
ACT
FD/HDX
Rear Panel
The rear panel accommodates the plug socket for connection of a standard three-pin power
plug. The S2Konnect Unmanaged Switches automatically adjust their power setting to any
supply voltage in the range of 100 to 240 VAC at 50-60 Hz.
Power consumption: 0,75A @100V
4
Important Information
Technical Support
If you encounter any problems, read the relevant section of the manual. If you cannot solve
your problems, consult our technical support.
If you contact our technical support engineers, have the following information ready:
• switch type
• configuration of your network
• type of cabling
• system documentation
Our support team can be reached following the instructions on our website.
Please go to www.s2konnect.com, support section.
You will also find the procedure for returning a switch for repair on that section.
S2Konnect cannot accept any returned product without an RMA number on the outer packaging.
i
The warranty does not apply to products that have been damaged by electrostatic discharge or
inadequate packaging
S2Konnect S-8180T
Color
Status
Off
On
Green
Off
Green
On
Green
Blinking
Yellow
On
Yellow
Blinking
Off
Green
On
Green
Blinking
Figure 7. Rear Panel of the S2Konnect S-8180T
Description
Power off
Power on
No link established
1000 MBit/s link established, no data is transferred
1000 MBit/s link established, and data is transferred
10 MBit/s link or 100 MBit/s link established, no
data is transferred
10 MBit/s link or 100 MBit/s link established, and
data is transferred
Operation in half-duplex mode
Operation in full-duplex mode
Collision detected at the port
Advertisement
Table of Contents
