Table of Contents
Advertisement
7
Safety Precautions
To protect yourself from injuries and avoid damage to the S2Konnect S-8180T Unmanaged
Switches, always observe the following safety instructions.
Avoiding injuries
Electrical current!
Electrical current from power, phone, and communications cables can be hazardous.
Never touch any electrical elements with bare hands.
To avoid potential shock hazards:
•
•
•
•
•
•
•
i
Electrical installations must comply with the safety regulations of the country in which they are
operated.
Avoiding damage
!
Electrostatic discharge!
Electrostatic discharge may damage or destroy the S2Konnect S-8180T Unmanaged Switches.
To avoid damaging the S2Konnect S-8180T Unmanaged Switches observe the following:
•
•
S2Konnect S-8180T
Do not carry out any installation, maintenance, or (re)configuration work during a
thunderstorm.
Do not connect or disconnect any power cables during a thunderstorm.
Unplug this device from its power source before cleaning. Use only a slightly dampened
label. If you are not sure of the type of your local power supply, consult your dealer or the
local power company.
Do not pinch, crimp or otherwise damage the power cord. If exposed to foot traffic, en-
sure that the cable is properly shielded and does not pose a tripped hazard.
If using an extension cord, make sure the total ampere rating of the products using the
cord does not exceed the extension cord's ampere rating.
Do not attempt to service this device, as opening or removing casing may expose you to
dangerous voltage points or other risks. Refer all servicing to qualified service personnel.
The S2Konnect S-8180T Unmanaged Switches should be serviced by qualified service
personnel under the following conditions:
•
The power cord is damaged or frayed.
•
Liquid has been spilled onto the product.
•
The product has been exposed to rain or water.
•
The product does not operate normally in accordance with the operating
instructions.
•
The device has been dropped or the casing had been damaged.
Never use force when working with the S2Konnect Unmanaged Switches.
Do not place the S2Konnect Unmanaged Switches on an unstable surface. The device
may fall causing serious damage to the device.
Advertisement
Table of Contents
