Mitsubishi HS-U778 Owner's Manual page 9

Hooking Up Your VCR
Connections to Satellite Receiver
®
If you have an RCA DSS
®
Panasonic DSS , Hughes DSS
™
Network satellite system, you can connect the satellite
receiver to your VCR and then set up the VCR to
change the channels of the satellite receiver. This will
allow you to program your VCR to make unattended
recordings from several different satellite channels.
1 Connect the red and white audio cable to AUDIO
OUT R and AUDIO OUT L on the satellite
receiver. Connect the other end to the AUDIO IN
R and AUDIO IN L on the back of the VCR. Match
the colors of the connectors to the cables.
2 Connect the S-video cable to S-VIDEO OUTPUT
on the satellite receiver. Connect the other end to
the S-VIDEO IN on the back of the VCR.
If your satellite receiver does not have S-VIDEO
OUTPUT, connect the video cable to VIDEO
OUTPUT on the satellite receiver. Connect the
other end to the VIDEO IN on the back of the
VCR.
3 See page 9 for IR Emitter connection.
connecting both a satellite receiver and a cable
box with audio video outputs
1 Connect the satellite receiver to the audio video
inputs on the back of the VCR as shown.
2 Connect the cable box to the audio video inputs on
the front of the VCR.
®
, Sony DSS , Toshiba DSS
® ®
, PRIMESTAR , or DISH
VCR Rear Panel
R AUDIO L/MONO VIDEO S-VIDEO
R L
Red White Yellow
Connect it only if the satellite
receiver does not have S-Video Output.
®
,
You cannot connect both a satellite receiver and a
digital cable box.
You may need to purchase an audio cable and an
S-video cable for this hookup.
If possible, you should have connected your VCR
to your TV with an S-Video cable. It will allow you
to watch the satellite video signal on your TV even
when the VCR is off if you set the Rear S-through
in the S-VHS Set-Up menu to ON.
If you connect your VCR to your TV with a
standard video cable, you will have to turn the
VCR on to watch the video signal from the
satellite receiver. You will be able to hear the
audio signal from your satellite receiver both when
the VCR is on and off.
When you connect a satellite receiver to the
S-video input on the back of the VCR, you have to
set the Rear S-input in the S-VHS Set-Up menu to
ON.
Refer to your Satellite Receiver Owner's Guide
for Satellite dish to Satellite receiver connections,
as well as other possible video connections to
your TV.
DSS ® is a registered trademark of DirecTV, Inc.
PRIMESTAR
DISH Network
IN 1
Satellite Receiver Rear Panel
S-VIDEO
Yellow
IMPORTANT
IMPORTANT
®
is a registered servicemark of PRIMESTAR Partners LP.
™
is a registered trademark of EchoStar Communications Corp.
VIDEO L AUDIO R
OUT
OUT
R
L
White Red
7