Mitsubishi HS-U778 Owner's Manual page 8

Hooking Up Your VCR
Connections to TV with Audio Video Inputs
Because you purchased a Hi-Fi VCR, you will want to
take advantage of its superior sound capability and
connect it to a stereo TV system with audio and video
inputs. This connection also helps maintain the best
picture quality.
1 Connect the red and white audio cable to AUDIO
OUT R (right) and AUDIO OUT L (left) on the
VCR. Connect the other end to the TV's AUDIO
IN RIGHT and AUDIO IN LEFT. Match the colors
of the connectors to the cables.
2 Connect the S-video cable to S-VIDEO OUT on
VCR. Connect the other end to S-VIDEO INPUT
on the TV.
IMPORTANT
IMPORTANT
If your TV does not have S-video connections, use
standard yellow video cable in step 2.
3 Set the RF converter to OFF. See page 48 for
instructions on this setting, which can be done at a
later time.
VCR Rear Panel
R AUDIO
R
Red
White
6
OUT
L VIDEO S-VIDEO
Yellow
supplied S-video cable
When you connect an S-video cable, please do
not connect a yellow video cable because it may
cause interference of the picture depending on
your TV.
supplied audio/video cable
TV Rear Panel
Your TV Owner' s Guide may have additional
suggestions for audio video hookups.
To connect your VCR to a mono (non-stereo) TV,
connect only the white AUDIO OUT L of the
VCR and the white AUDIO INPUT of the TV.
Since the TV is not stereo, you cannot take
advantage of your VCR's Hi-Fi stereo sound.
If you have an older TV without audio video
inputs, simply connect only the antenna or cable
as shown on the previous page.
White
Yellow
INPUT-1
INPUT-2
OUTPUT
MONITOR/TUNER
S-VIDEO VIDEO
IMPORTANT
IMPORTANT
Red
L R
R
L (MONO) R
AUDIO