Light Mode - NEC PX803UL-WH User Manual

[LIGHT MODE]

Adjusting the energy savings settings and the brightness of each projector in multi-screen projection. For energy
savings settings, see page
[LIGHT MODE]".
LIGHT MODE NORMAL
ECO1
ECO2
CONSTANT OFF
BRIGHTNESS
ON
ADJUST
TIP:
• Brightness normally decreases with use, but by selecting [CONSTANT BRIGHTNESS] mode, sensors inside the projector detect
brightness and automatically adjust the output, thereby maintaining a constant brightness throughout the life of the light module.
However, if output is already at its maximum, brightness will decrease with use.
For this reason, when using multi-screen projection, it is recommended to adjust the brightness to a slightly lower level, then
setting the [CONSTANT BRIGHTNESS] mode to [ON].
[REF. WHITE BALANCE]
This feature allows you to adjust the white balance for all signals.
The white and black levels of the signal are adjusted for optimum color reproduction.
CONTRAST R/CONTRAST G/CONTRAST B
������������������������������ These adjust the picture's white color�
BRIGHTNESS R/BRIGHTNESS G/BRIGHTNESS B
������������������������������ These adjust the picture's black color�
3D GLASSES
Select 3D glasses method.
DLP® Link ������������� Select when using DLP
OTHERS ����������������� Select when using a non 3D emitter type glasses� It is required to connect the 3D emitter to the 3D SYNC
terminal of this projector� Please refer to page
for this projector�
39 "3-6. Changing LIGHT MODE/Checking Energy-Saving Effect Using LIGHT MODE
The light module luminance (brightness) will become 100% and the screen will turn bright.
By controlling the brightness and fan speed according to the selected setting, energy can
be saved and motion noise and the power consumption can be lowered.
Can be selected when [CONSTANT BRIGHTNESS] mode is set to [OFF].
[CONSTANT BRIGHTNESS] mode will be canceled.
Maintains the brightness that is in effect at the time [ON] is selected. Unless [OFF] is se-
lected, the same settings will remain in effect even when the projector is turned off.
• To re-adjust the brightness, first turn this setting OFF before making further adjustments.
NOTE:
• [CONSTANT BRIGHTNESS] mode is a function used to maintain the brightness at a constant
level. Color will not be fixed.
Brightness can be adjusted in 1% increments from 20 to 100%.
When several projectors are used for multi-screen projection, the brightness can be ad-
justed individually on each projector.
The adjustment is effective when [NORMAL] [LIGHT MODE] is selected and [CONSTANT
BRIGHTNESS] mode is turned [OFF].
Link type 3D glasses�
®
50 about recommended items of 3D glasses and 3D emitter
116
5. Using On-Screen Menu