Terminals Features - NEC PX803UL-WH User Manual

Terminals Features

1. COMPUTER IN (Mini D-Sub 15 Pin)
(→ page 14, 143, 149, 184)
2. DisplayPort IN Terminal (DisplayPort 20 Pin)
(→ page 144, 184)
3. HDMI IN Terminal (Type A)
(→ page 144, 146, 150, 184)
4. BNC Input [R/Cr/CV, G/Y/Y, B/Cb/C, H, V] Termi-
nals (BNC × 5)
(→ page 143, 148)
5. BNC (Y/C) Input Terminal (BNC × 2)
(→ page 148)
6. BNC (CV) Input Terminal (BNC × 1)
(→ page 148)
7. USB Port (Type A)
(→ page 185)
(For future expansion. This port allows for power sup-
ply.)
8. HDMI OUT Terminal (Type A)
(→ page 147)
9. Ethernet/HDBaseT Port (RJ-45)
(→ page 152, 153, 185)
10. 3D SYNC Terminal (Mini DIN 3 Pin)
(→ page 50)
11. PC CONTROL Port (D-Sub 9 Pin)
(→ page 185, 191)
Use this port to connect a PC or control system.
This enables you to control the projector using serial
communication protocol. If you are writing your own
program, typical PC control codes are on page 191.
8
9
14 12 11
3 2 1
6
13 10
12. REMOTE Terminal (Stereo Mini)
Use this jack for wired remote control of the projector
using a commercially available remote cable with ⌀3.5
stereo mini-plug (without resistance).
Connect the projector and the supplied remote control
using a commercially available wired remote control
cable.
(→ page 12)
NOTE:
• When a remote control cable is connected to the REMOTE
terminal, infrared remote control operations cannot be per-
formed.
• Power cannot be supplied from the REMOTE terminal to the
remote control.
• When [HDBaseT] is selected in the [REMOTE SENSOR]
and the projector is connected to a commercially-available
transmission device that supports HDBaseT, remote control
operations in infra-red cannot be carried out if transmission
of remote control signals has been set up in the transmission
device. However, remote control using infrared rays can be
carried out when the power supply of the transmission device
is switched off.
13. SLOT
(→ page 175)
14. Service terminal
For service only
9
1. Introduction
7
4
5