Charging The Battery - Sapac TL 2000 Operation And Assembly Instructions

signal wire(sometimes white). The receiver antenna is best fully extended and routed away from other wires where
practical.
Run the antenna out of the fuselage and up to the top of the fin for best results. Use some tape to hold in place.
DO NOT shorten, cut or roll up the antenna as this will reduce the range of control.
Checking Control Surfaces for Correct Direction of Travel – VERY IMPORTANT :
The direction the model will go, depends on the direction the control surfaces move when you move the stick
on the transmitter. Please check that the Ailerons ( wings ) and the Elevator ( Tail ) work in accordance with
the following diagrams.
The battery is charged using the supplied "Balance Charger".
The individual cells are charged separately to correctly balance the battery
cells – so plug the 4 wire connector into the purple charger.
The battery will take around 1.5 hours to charge from flat. The RED light
indicates all connections are correct and when the Green Charge light
(Indicates charging is underway) goes OFF - you know the battery is fully
charged.

CHARGING THE BATTERY

The LiPo battery provides power for the receiver, the
servos and the motor.
The model operates on a "LiPo" battery (similar to
your mobile phone batt.). Do not discharge these
batteries until "flat" - As soon as the model starts to
loose power – Re charge the battery fully. Always
charge the battery before storage.
8