Table of Contents
Advertisement
6-3 Head Switching Point Adjustment
1) Playback the alignment tape.
2) Press the "TEST" button on Function PCB to set the adjustment mode. (See Fig. 6-2 )
3) Press the "SP/LP" button of remote control then adjustment is operated automatically. (See Fig. 6-1)
6-4 NVRAM Option Setting
1) NVRAM Option is adjusted at production line basically.
2) In case Micom (IC601) and NVRAM (IC605 ; EEPROM) is replaced, be sure to set the corresponding option number of the reqaired
model. (If the option is not set, the unit is not operated.)
1) Press the "TEST" button on Function Timer PCB to set the adjustment mode. (See Fig. 6-2)
2) Press the "MENU" button on the remote control about 5 seconds then option setting display is appeared.
(See Fig. 6-4 and 6-5)
3) Select the option number (See Table 6-1) of corresponding model with "
control.
4) If selecting the option number is completed, press the "ENTER" button of remote control.
(If "ENTER)" button is pressed, the selected number is changes reversed color. ; See Fig. 6-4)
5) Press the "RETURN" button of remote control again to store the option number.
("PLEASE WAIT" is displayed for a second as shown Fig. 6-5 and this setting is completed.)
6) Turn the Power off.
01
02
03 04
09 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32
33 34 35 36 37 38 39 40
41 42 43 44 45 46 47 48
49 50 51 52 53 54 55 56
57 58 59 60 61 62 63 64
65 66 67 68 69 70 71 72
CNG:OK SAVE:RETURN
Fig. 6-4
MODELS
OPTION NUMBER
SLV-D900G
3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 15, 27, 33, 34, 35, 40, 41, 45, 47, 52, 59, 60, 61, 63.
SLV-D900E
2, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 15, 34, 35, 40, 42, 45, 47, 52, 59, 60, 61, 63.
05
06 07 08
01
02
09 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32
33 34 35 36 37 38 39 40
41 42 43 44 45 46 47 48
49 50 51 52 53 54 55 56
57 58 59 60 61 62 63 64
65 66 67 68 69 70 71 72
<Table 6-1>
6-4E
" button on the remote
03 04
05
06 07 08
PLEASE WAIT
Fig. 6-5
Advertisement
Table of Contents
