Panasonic NN-CS894S Service Manual page 18

5. Release the catch hooks on harness protector to seperate
lead wire harness from harness protector.
6. Slide the door (U) left and right to release the pin from door
hinge, then remove door (U) from oven cavity.
• Draw out the lead wire harness toward the front side of
the unit.
7. Remove 8 screws holding door E on door A (U).
NOTE:
After replacement of the defective component parts of
the door, reassemble it properly and adjustment so as
to prevent an
Adjustment of the door assembly(Refer page 28).
1. When mounting the door to the oven, be sure to adjust the
door parallel to the cavity front plate by moving hinges back
or forward.
2. Adjust so that the upper portion of the door will touch firmly
to the oven cavity front plate, without pushing the door.
If the door assembly is not mounted properly, microwave
power may leak from the clearance between the door and
oven.
3. Be sure the gap between left or right portion of door
assembly and cavity front plate will be 1.0±0.3mm.
4. Always perform the microwave leakage measurement test
after installation and adjustment of door assembly.
19
excessive microwave
NN-CS894S
leakage.